Home | Classifieds | History | Technical | Links | Store | About Us | Email
Topics Topics Edit Profile Profile Help/Instructions Help Member List Register  
Search Last 1|3|7 Days Search Search Tree View Tree View  

Gray Marine specs

Old Marine Engine » Gray Motor Co - early 1 and 2 cylinder » Gray Marine specs « Previous Next »

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

Frank Petran
Member
Username: frank_petran

Post Number: 20
Registered: 05-2009
Posted on Sunday, May 24, 2009 - 09:51 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Moderator/Admin Only)

Questions again. Does any one have any idea or know the actual crankshaft end play clearance and if so where is it measured? As my engine has a tappered shaft ( approx 1.305 to 1.2 inches ) for the flywheel (haven't located one yet) does the flywheel fit thight up against the bevel gear or is there a spacer and if so what is the thicknes of the spacer? The other end of the crank is the output flange for a prop shaft and that has a tappered pin locating it against a spacer. Is that where a plunger type water pump would have the ecentric cam for the water pump. I haven't taken the motor appart yet but I want to know as much as possible before I do. Thanks Frank
Top of pagePrevious messageNext messageBottom of page Link to this message

Frank Petran
Member
Username: frank_petran

Post Number: 21
Registered: 05-2009
Posted on Monday, May 25, 2009 - 09:28 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Moderator/Admin Only)

More Questions. Does any one know what the operating water temperature is for a Gray 4.5R or for that matter any Gray 2 cycle? I own 2 boats that have Gray 4 and 6 cylinder engines in them and I have to put a valued bypass line from the water outlet on the head back into the water pump to recirculate hot water to bring the engine temperature up to about 120 Degrees F. The water pump on the 4.5R that is on the engine has 2 outlets, one directly into the mounting flange that mates to the flange of the engine which is ¼ pipe and the other is a 3/8 pipe. The engine outlet is ½ pipe. The engine has a 3/8-pipe inlet just under the exhaust flange. When I took the pump off the engine the flange had a gasket partially covering the ¼ pipe outlet/inlet and the 3/8-pipe outlet had a plug in it. Which one should I use?

Add Your Message Here
Post:
Bold text Italics Underline Create a hyperlink Insert a clipart image

Username: Posting Information:
This is a public posting area. Enter your username and password if you have an account. Otherwise, enter your full name as your username and leave the password blank. Your e-mail address is optional.
Password:
E-mail:
Options: Automatically activate URLs in message
Action:

Administration Administration Log Out Log Out   Previous Page Previous Page Next Page Next Page

Home | Classifieds | History | Technical | Links | Store | About Us | Email
&copy 2005 OldMarineEngine.com, P.O. Box 188, Forest Dale, VT 05745-0188 • Phone: 802-247-4864 • All rights reserved.
   Marine Engine Seloc Repair Manual Lookup Tool

marine gas engine repair and restoration