Home | Classifieds | History | Technical | Links | Store | About Us | Email
Topics Topics Edit Profile Profile Help/Instructions Help Member List Register  
Search Last 1|3|7 Days Search Search Tree View Tree View  

R3M Indirect cooling. Anybody tried t...

Old Marine Engine » Stuart Turner » R3M Indirect cooling. Anybody tried this? « Previous Next »

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

Nick Gilchrist
Member
Username: nick_gilchrist

Post Number: 4
Registered: 09-2006
Posted on Wednesday, December 27, 2006 - 06:01 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Moderator/Admin Only)

Seasons greetings Old Marine Engineers, from the SE of England.
I have just acquired a 1949 R3M which I am planning to refurbish. Does anybody have experience of indirect cooling for this? It's amazing to me that the engine circulates raw water through the cast iron parts - what stops it rusting away? I know that the engine has survived nearly sixty years, but I want it to go on for another sixty, so I am looking for an elegant solution to indirectly cooling it, maybe keel cooling. If anybody has successfully achieved this, I would be most grateful for any comments.
Many thanks,

Nick
Top of pagePrevious messageNext messageBottom of page Link to this message

David Myers
Member
Username: dave_myers

Post Number: 7
Registered: 11-2006


Posted on Wednesday, December 27, 2006 - 06:34 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Moderator/Admin Only)

Hello Nick,
Keel Cooling is very simple and efficient. I have used this on a number of craft to avoid the seawater problems. The rule of thumb is 1 foot of 3/4 inch hard drawn copper pipe per horsepower. I just use Skin fittings through the hull and the pipe supported by a couple of copper saddles to the keel. Run out of the engine to the pipe and return to the pump via an expansion chamber. An expansion tank off an old Morris/ Austin 1100 or whatever you can get hold of as long as it has a pressure cap. The return water goes in the top and the bottom of the tank goes to the pump inlet. Make a mixture of 50% radiator inhibitor and 50% water. The tank only needs to just over half full to allow for expansion when it gets hot. Works very well and is a lot cheaper than a heat exchanger.
Hope this helps.

Dave
Top of pagePrevious messageNext messageBottom of page Link to this message

Nick Gilchrist
Member
Username: nick_gilchrist

Post Number: 5
Registered: 09-2006
Posted on Wednesday, December 27, 2006 - 07:24 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Moderator/Admin Only)

Hello Dave,
Well that was a lightning quick reply! Very much appreciated and I'll give this a go.
Best regards,
Nick

Add Your Message Here
Post:
Bold text Italics Underline Create a hyperlink Insert a clipart image

Username: Posting Information:
This is a public posting area. Enter your username and password if you have an account. Otherwise, enter your full name as your username and leave the password blank. Your e-mail address is optional.
Password:
E-mail:
Options: Automatically activate URLs in message
Action:

Administration Administration Log Out Log Out   Previous Page Previous Page Next Page Next Page

Home | Classifieds | History | Technical | Links | Store | About Us | Email
&copy 2005 OldMarineEngine.com, P.O. Box 188, Forest Dale, VT 05745-0188 • Phone: 802-247-4864 • All rights reserved.
   Marine Engine Seloc Repair Manual Lookup Tool

marine gas engine repair and restoration