|
| Author |
Message |
    
Glowell
| | Posted on Saturday, November 17, 2001 - 08:59 am: | 
|
I have a Volvo MD1 that does not have a water temp or oil temp meters (it does have an oil pressure gauge). I would like to add temp gauges but there is no place for senders. The water drain plug is in a place that will not allow for a sender. I could drill and tap a fitting in the head or block, but scared to do so. Any suggestions? |
Gil
| | Posted on Monday, November 19, 2001 - 09:53 am: |
|
Glowell,
You can install a fitting for a water temperature gauge at the point shown on the picture below.
Oil temperature gauge shouldn't be neccessary on this engine, oil will run cooler than the engine.
Regards,
Gil Plumb |
|
|
|
|
